Lithium battery raise voltage and down voltage method
We will need to seeking the solution to raise or down the voltage for the battery , what shall we do ?
First, let the lithium battery drop to 3.3V through the step-down chip, then power the microcontroller and the Bluetooth module, and plan to raise it to 7V to carry a load.
Result: The Bluetooth module does not work and cannot be searched. Remove the Bluetooth, the microcontroller and the load work normally. When the microcontroller is removed, the Bluetooth and the load work normally. When the voltage drop is not used, when a set of power is supplied separately, all three work normally.
Description: xc6206 for step-down and fd6291 for step-up.
2. Lithium battery boost and buck problems
Let's analyze the reasons for the above problems, find out the common faults of the lithium battery buck-boost, and learn together.
Lithium-ion batteries have a certain range of cell voltage. For example, the normal working voltage range of lithium iron phosphate batteries is 2.5V-3.65V, and the normal working voltage range of lithium manganese oxide and ternary batteries is 3V-4.2V.
In the application of lithium-ion batteries, when the total voltage is 60V and below, a battery protection board is required. Above 60V, a battery management system (BMS) is required. The role of these two devices is to protect the battery from working properly.
Note that after the number of strings of the battery pack is determined, the battery pack voltage cannot be adjusted at will. That is, the voltage change of the battery pack can only change within the normal working voltage range: when charging, it rises from the lower voltage limit to the upper voltage limit. When using electricity, the voltage drops from the upper limit to the lower limit.
Understand this problem, if you want to make the lithium battery have a wide range of voltage rise and fall, you can adjust it at will.
The best solution: make a set of battery packs, equip a suitable inverter, and equip a DC voltage regulator to meet the voltage step-up and step-down requirements of lithium batteries.
Note: This method is rarely used in practical applications, unless the AC power used is often out of power, or when solar or wind energy is used to charge the battery pack, this method of step-up and step-down will be considered.
The above method of step-up and step-down of the lithium battery can be used in the experiment, and the effect is good for research and learning.
Contact Person: Ms. Alice